WRING: Speaker Cleaner & Eject

• WRING Pro: a weekly or yearly subscription, or Lifetime — pay once, no subscription. • The free version: 1 water or dust cycle a week, plus one more a day for watching an ad; the speaker test, tone generator and dB meter once a week each. • Close the offer screen with ✕ to use WRING for free right away. • Smaller fixes and improvements.

Water in your phone speaker? WRING is a speaker cleaner and water eject app: a controlled sound cycle pushes trapped water out of the speaker grille in about a minute — no ultrasound, no tools. Muffled sound after a shower, the rain, a pool or a sink is almost always water sitting in the mesh. The longer it stays, the worse it gets: water dries into mineral spots that dull the speaker for good. Use WRING as a water cleaner and liquid remover right away — the sooner you get water out of the phone speaker, the better. WATER EJECT Three modes remove water from both speakers: each plays a low part for the bottom loudspeaker and a higher one for the ear speaker (earpiece) at the top, 100–1500 Hz in all: • Pulse — short low pushes wring the water out. The standard cycle. • Wave — smooth sweeps up and down for water that sits deeper. • Deep — pulses, then waves, then a second pass, for a phone that went all the way under. Choose 30, 60 or 90 seconds and the speaker: top, bottom or both. Still muffled? One tap runs it again — a soaked grille sometimes needs two rounds to clear the speaker. SPEAKER CLEANER FOR DUST Crackle and buzz are usually lint, not water. Three modes shake it loose from the speaker grille, so you can clean the speaker without pins or brushes: • Shake — a low rumble. The standard cycle. • Buzz — a high buzz for fine dust and lint caught in the mesh. • Sweep — one long sweep from low to high, for a grille that still sounds dull. MADE FOR WET HANDS Lay the phone face down and the cycle starts on its own — no fighting with a wet screen. Volume goes to 100% for the cycle and your own level comes back afterwards. The phone vibrates with the sound to help loosen water and dust. Both can be turned off in Settings. SPEAKER TEST Hear the top and bottom speakers alone or together, with deep bass that shows rattle and buzz — so you know which speaker is weak, and whether the speaker is the problem at all. If your phone has them the other way round, swap top and bottom right there. TONE GENERATOR AND DB METER A pure tone from 20 Hz to 20 kHz: swipe up or down to set the frequency. The dB meter shows the sound level, its average, minimum and maximum and the strongest frequency, and takes a photo with the reading on it. TABLETS AND FOLDABLES WRING scales to the bigger screen, and the speaker test plays every speaker at once. WHY THERE IS NO ULTRASOUND WRING does not use ultrasound. The cycle uses audible frequencies at normal playback level — the level a song plays at, aimed at moving water. Nothing is overdriven. Keep the phone away from your ear while it runs. FOR BEST RESULTS 1. Wipe the outside dry. 2. Put the phone face down on a flat surface. 3. Start the cycle and let it finish. Run it as soon as you notice the problem. WHAT IT CANNOT DO WRING clears the speaker grille. It cannot dry water that has already reached the inside of the phone. If your phone was submerged, power it off, let it dry and take it to a repair shop. Rice does not help either — that is a myth. PRIVACY No account. The microphone is used only by the dB meter while it measures, and nothing is ever recorded. Ads appear only in the free version. Purchases are processed by Google Play; your subscription status is checked by our payment provider with an anonymous ID. FREE AND PRO WRING is free to use with ads: 1 water or dust cycle a week, one more a day for watching an ad, and the other tools once a week each. WRING Pro removes the limits and the ads. Pro is a weekly or yearly subscription, or a one-time Lifetime purchase. Manage or cancel any time in Google Play › Payments & subscriptions › Subscriptions. Terms: https://wringdry.app/terms.html Privacy: https://wringdry.app/privacy.html Support: support@wringdry.app